1, this equipment should be installed in the pump is higher than the concrete foundation of 100mm above the ground on the fan tower installation, and on the same plane, the level of concrete surface error less than 2mm.
2, transport installation should pay attention to protection, not damaged body and parts.
3, the equipment factory, the use of packaging and transportation by the company to send personnel to the site installation and debugging, but also the overall installation, the site directly hoisted in place.
4, the installation and operation of the equipment in the outdoors, in the winter to cope with the bottom of the tank parts of antifreeze, cold areas to consider appropriate heating protection. Use of glass fiber reinforced plastic waste gas purification tower
5, the equipment at the bottom of the pool has a liquid level mark, before use must be marked by the level of liquid absorption. The height of the static liquid level is half of the water level in the tank. During the course of the application should be checked every day and pay attention to the absorption of liquid.
6, the pump must first neutralization liquid before use, not without causing damage to pump liquid idling. Use should first open circulating water pump for 2-3 minutes, then fan, stop, stop fan for 1-2 minutes, then stop circulating water pump, use should be strictly in accordance with the provisions of the operation, if the damage caused by improper use of the pump, the producers do not bear any responsibility, responsible for all the losses by use.
7, the ventilator with the rear or front blowing, ventilation should check whether the pipeline is connected, the valve should be opened, no foreign body in the pipeline can run.
8, regular inspection, should be based on the use of regular inspection of the bottom of the tower body water tank acid-base concentration and exhaust gas purification degree, more than the standard, should be replaced in the bottom of the pool water absorption.
9, the use of lye as absorption liquid, alkali liquid (NaOH) should be used in liquid water, the concentration is controlled in the range of 5%-6% for a period of time, the operation of the equipment, acid-base and produce salts, over a certain concentration of crystallization, clogging and filler and damage the seal and pump impeller, the salt concentration of more than 33% should be timely emissions, and add new lye can continue to use.
10, the equipment should be a half a year overhaul, check the spray tube packing and packing of the situation, and its cleaning.
11, the selection of equipment, the space required to purify the exhaust air handling equipment must be consistent with the wind, is not responsible for the exhaust air purification environment requirements. Use of glass fiber reinforced plastic waste gas purification tower