1. After the site has been completed, it should be maintained for 7-10 days before it can be put into use. During the period of maintenance, water or other solution should be avoided to soak the surface
2, all employees must enter the shop to replace rubber soled shoes (black shoes can not wear foam bottom) (to avoid outside of the sediment into the workshop and scratch the ground)
3, any hardware: such as iron chairs, iron table, iron shelves, should be soft plastic, rubber or leather pad of paper wrapped up in use process to scratch the ground 4, tractor pull will be the need for full board up off the ground with their feet, turning special attention to when you board not to scratch the surface angle
5, clean the ground, please use soft absorbent good mop or wet and dry dual-use vacuum cleaner, can be cleaned with water or detergent, but please pay attention to the ground slippery
6, if the use of a longer time and cause wear or scraping, small area can be partial repair, if the area is larger, it is recommended re roll coating once
7, before the equipment into the factory, on the floor on the hard cardboard boxes at the bottom, so as not to transport equipment in the process of scratching the ground
8, please use the wheel cart, a rigid or flexible rubber wheel, and separate inside and outside plant use
9, according to the requirements of the ground to do waxing treatment (its effect can prevent scratches on the ground)